Short version: we manufacture self-adhesive carpet protection film and sell it direct to US painting crews, flooring installers, general contractors, restoration firms and distributors. Rolls are quoted in inches and square feet, samples are free at your roll width, and private label is available. Email sales@chidecor.com with the square footage and carpet type and you get a written quote with roll counts and freight to your US port.
Roll sizes US jobs actually use
US ordering runs on inches, feet and mil, so everything on this page is in those units. A 200 ft roll is the standard length; the width is what changes from job to job.
| Width | Length | Coverage per roll | Where it fits |
|---|---|---|---|
| 24 in (61 cm) | 200 ft (61 m) | 400 sq ft | Stairs, landings, hallways, bathrooms, small bedrooms, punch-list runs |
| 36 in (91 cm) | 200 ft (61 m) | 600 sq ft | Standard residential rooms, single-door commercial bays, apartment turns |
| 48 in (122 cm) | 200 ft (61 m) | 800 sq ft | Open-plan floors, retail fit-outs, clubhouses, large residential |
Thickness is quoted in mil and mm together: 2.4 mil = 0.06 mm, 2.8 mil = 0.07 mm, 3.1 mil = 0.08 mm. For a job that only sees foot traffic and ladders, the lighter gauge is enough. For wheelbarrows, scaffold feet, dropped tools and repeated moving of material, go up a gauge – the film has to resist puncture, not just cover.
Custom widths are cut to order when a distributor needs a width that is not on this list.
Match the film to the carpet, not just to the floor
This is where most carpet film complaints come from, and it is the first question we ask a US buyer.
| Carpet type | What goes wrong with a generic roll | What we specify |
|---|---|---|
| Commercial loop pile (tight, low profile) | Usually fine; failure comes from too much tack on a long install | Standard low-tack grade |
| Cut pile / textured residential | Pile lifts and the film grabs fibers on removal | Lower tack, matched to pile height |
| Plush, frieze, shag, wool blend | Film crushes the pile and pulls fibers; retail-grade rolls often state they are not for plush carpet | Lowest-tack grade and a removal time limit agreed before the order |
| Berber / sisal-look loop | Loop pulls and runs if the film is removed fast or at an angle | Low-tack grade, removal at a shallow angle, in the direction of the pile |
| Stairs and edges | Curling at nosings, film sticking to itself while installing | Narrower roll width so the film spans the tread with minimal wrap |
When the floor under the carpet is not carpet
Many US jobs cover more than one surface, and carpet film is not the right product for all of them. If the same crew also has to protect hardwood, LVT, vinyl, tile, stone or a finished concrete slab, tell us and we quote a surface-matched film alongside the carpet roll instead of shipping one grade for everything. Carpet film on a polished wood floor is how residue complaints start.
Where US buyers put this film
- Painting and drywall – cut pile in occupied homes, plastic over carpet before spray, texture and touch-up.
- Flooring installation
- Remodels and additions – carpet paths from the door to the work area, stairs, and the corridor the crew walks twenty times a day.
- Retail and commercial fit-out – open-plan floors under lifts, carts and material staging.
- Restoration and water damage
- Apartment turns and moving crews
- Final clean and handover
– protecting the existing carpet in the rooms that are not being replaced, and protecting new carpet after install until the punch list is done.
– keeping clean carpet separated from the work zone while drying equipment moves through.
– short-term cover for a unit between tenants, and protection on move-in and move-out days.
– a fresh roll on the floor for the walkthrough, then it comes up in one piece.
How a US order runs, step by step
- Send two numbers and one word. Square footage (or the floor plan), the roll width you want, and the carpet type. If you do not know the width, send the room sizes and we work it out.
- We confirm the specification in writing. Gauge, tack level, roll width, roll count including a 10-15% allowance for overlap, doorways and cutting in at walls, packing and pallet configuration.
- Free sample at your roll width. A short length of the exact film, so your crew can try it on the actual carpet before you commit to a pallet.
- Quotation, then production. MOQ, lead time and price depend on roll width and annual volume – we state them in the quote rather than in marketing copy, because they move with the order.
- Export packing and freight to your US port. Rolls are packed for container or LCL shipment, with the pallet and carton configuration agreed up front so the receiving side knows what arrives. Freight is quoted separately, FOB or CIF, to the port you nominate.
What a US buyer receives with the shipment
- Spec sheet matching the confirmed order: gauge, width, length, coverage per roll, tack level and removal guidance.
- Packing list and pallet configuration, so receiving and put-away are predictable.
- Removal instructions for the crew – direction, angle, temperature and the maximum time the film stays down for that carpet type.
- Compliance and test documents only where they exist for the specific product and are stated in the quote. We do not put badges on a page for certificates we cannot hand over.
Distributors and private label
If you resell rather than install, the order changes shape: pallet quantities, custom widths, printed cores, branded cartons and a label that carries your SKU instead of ours. Private label runs are quoted per width and per annual volume, and the artwork and carton specification are confirmed before production starts. Distributors who carry both carpet film and surface film usually consolidate the two into one shipment – say so at quote stage and we build the pallet around it.
Why buyers move from retail rolls to a manufacturer
- Width and gauge on request – retail packs are fixed at 24 in and one gauge; a contractor’s mix of stairs, rooms and open floors is not.
- Written spec before money changes hands – not a product page claim.
- Sample at the actual width – the crew tests the film on the actual carpet, not on a photo.
- One partner for carpet and hard-surface film
- Private label for distributors
– fewer suppliers, one shipment, one set of documents.
– your brand on the core and carton.
FAQ
Do you ship to the United States?
Yes. Orders ship from China to the US port you nominate, FOB or CIF, in containers or as LCL. Freight is quoted separately against the actual volume, so the number you see is the number you pay for that shipment.
How many rolls do I need for 1,000 sq ft?
At 24 in x 200 ft one roll covers 400 sq ft, so 1,000 sq ft is three rolls once overlap and cutting are allowed for. At 36 in it is two rolls. Send the square footage and we confirm the count in writing.
Is the film reverse-wound?
We wind to the configuration agreed on the order and state it in the spec sheet. If your crew is used to a reverse-wound roll where the adhesive faces outward and you push the core forward, say so before production – the winding is set at that stage, not at the dock.
How long can it stay down?
It depends on the carpet and the grade. We agree a maximum dwell time for your carpet type before the order ships and write it on the removal instruction. Leaving any carpet film down longer than the carpet allows is how pile lift and adhesive transfer happen.
Will it leave residue?
The adhesive is specified for clean release against the surface it is made for, and the removal instruction tells the crew how to take it up. Carpet film on hardwood, LVT or vinyl is a different adhesive – if that surface is in the same job, order the surface-matched film.
Does it hold up to wheelbarrows and dropped tools?
Choose the gauge for the traffic. Light foot traffic and ladders do not need the heavy gauge; demolition carts, scaffold feet and staged material do. Tell us what crosses the floor and we match the gauge instead of defaulting to the thinnest roll.
What is the MOQ?
MOQ depends on roll width and whether it is a stock width or a custom cut, and it is stated in the written quote. Private label runs have their own MOQ by width and annual volume.
Can I get a sample before ordering?
Yes – a free sample at your roll width. Use the sample and quote form or email sales@chidecor.com with the width and carpet type.
Start with the two numbers
Square footage and carpet type are enough to get a real answer. Send them to sales@chidecor.com, message +86 159 0082 9072 on WhatsApp, or use the form below and we reply with roll counts, the matched grade and freight to your port.
Product detail: carpet and floor protection film. Manufacturer background: carpet protection film manufacturer. Specification questions: buyer’s guide. Roll math by area: coverage calculator.
Roll-by-roll maths for real US job sizes – a 1,000 sq ft open floor, a three-bedroom house, stairs and a 2,500 sq ft retail bay – is worked through in how many rolls of carpet protection film you need.
Plush, frieze and shag carpet need a different grade and a shorter dwell time than commercial loop pile; the failure modes and what to specify instead are set out in carpet protection film for plush carpet.




